INOX

Gel promoting complete polymerisation of dental composites

Application:

INOX protects the surface of composites by blocking oxygen access during the light-curing process. This prevents an oxygen inhibition layer from forming on the composite surface, increasing the efficiency of the polymerization process.

INOX Gel is intended for use during:

  • polymerisation process of light-hardened composites;
  • prosthetic treatments performed with the use of dental cement (e.g. placing veneers, inlays, onlays), in order to promote complete polymerisation of composites.

INOX can also be used as a try-in gel for cementing of prosthetic works.

Advantages:

INOX Gel makes the polymerized composite:

HARDER – fully polymerized
SMOOTHER – better prepared for finishing
MORE DURABLE – more scratch- and abrasion-resistant
MORE AESTHETIC – less susceptible to discoloration

Active substances:

propanetriol (glycerol), Ph Eur purified water, gel base.

Available packages:
syringe of 2 ml + set of applicators

MEGA PACK 4x syringe of 2 ml + set of applicators

 

 

FOR PROFESSIONAL DENTAL USE ONLY

 

 

 

Add to Wishlist
Browse Wishlist
Browse Wishlist
SKU: N/A Category:
Share

Available Options:

Size

black, blue, brown

Polymerisation of light-cured composites:

  1. Apply and form the last composite coat, apply INOX Gel without to¬uching the composite coat with the applicator. The gel layer must tightly cover the whole surface of the dental restoration and stay in place during the polymerisation process (Pic. 2).
  2. Light cure through the gel coat.
  3. Wash out INOX Gel after the polymerisation process has been finished.
  4. Trim and polish the composite surface as needed.

1. When the restoration has been seated, remove excess resin cement as needed (Pic. 1).

2. Apply the INOX Gel on the marginal area of the restoration (veneer, inlay, onlay) without touching the composite coat with the applicator. The gel layer must tightly cover the whole surface of the dental restoration and stay in place during the polymerisation process (Pic. 2).

3. Light cure through the gel coat (Pic. 3).
4. Wash out INOX Gel after the polymerisation process has been finished (Pic. 4).
5. Trim and polish the composite surface as needed.

Related products